Siemens SINUMERIK 802D sl Instrukcja Obsługi Pobierz pdf (Strona 35)

Manual machining

5.2 Display and operator control optios in the main screen for "Manual Machine Plus"

Manual Machine Plus Turning

Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Controlling the axes and spindle

In manual machining mode, the axes and spindle can be controlled by the following

methods:

● The compound slide rest is controlled by:

–

Handwheels (Page 39) for the X and Z axes, or

–

Axis direction switch (Page 39)

● The spindle is controlled by:

–

Spindle direction of rotation switch (Page 40)

Values displayed in the position display and T, F, S

Figure 5-2 Main screen for "Manual Machine Plus", position display relative

Displayed values Meaning

In front of axis letters

+/-

• Current traversing direction of axes

S value/S type %

• The programmed value for either the spindle speed (rev/min) or the cutting rate (m/min)

The display corresponds to the settings for the machining technology data.

• Current position of the spindle override switch in %.

F value/F type %

• Programmed feed value

in either "m/min" or "mm/Rev", depending on the settings for the machining technology data.

• Current position of the feedrate override switch in %.

T value

• Tool number of the tool used

D value

• Tool offset applied

INC value

• Handwheel pulse weighting setting

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 129 130

Brak uwag

Siemens SINUMERIK 802D sl Instrukcja Obsługi Strona 35