Siemens Advance Network Gateway Instrukcja Użytkownika Pobierz pdf (Strona 38)

Ethernet Connections, Continued

Installation

Do not perform the following procedure until you have defined the IP and

Subnetmask addresses; see Chapter 3, Data Communications Setup.

Step Action

1. Connect the incoming Ethernet line from the Hub to the

RJ-45 STP connector on the ANCB board.

RJ45 STP

Connector

2. Place the ANG_EN AC Power Supply (Mains) circuit

breaker to ON. On the ANG_EN Power Supply Assembly

place toggle ON/OFF switch to ON (Figure 2-4).

3. After the ANG_EN has been connected to a hub and both

the ANG_EN and hub have been powered on, verify the

connection by looking at the LEDs visible on the top card

edge of the ANCB; see page

50, ANCB LEDs Description

and Operation.

24 • Installation 2000590-001

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 87 88

Brak uwag

Siemens Advance Network Gateway Instrukcja Użytkownika Strona 38