Siemens FIREFINDER-XLS Instrukcja Szybki Start Pobierz pdf (Strona 17)

DESCRIPTION 1-13

CHAPTER 1 | FIREFINDER-XLS INSTALLATION, OPERATION AND MAINTENANCE MANUAL

HMS-2S and HMS-SA The HMS-2S/-SA is an intelligent manual station designed to interface with a DLC

loop. The HMS-2S/-SA manual station housing has a pull down lever that locks in

position after releasing a spring loaded switch. To indicate the manual station is

activated, the pull down lever remains down and locked until the station is physically

reset. The HMS-SA manual station has a set of normally closed auxiliary contacts

which are available for releasing door holders and magnetic door locks.

The HMS-2S has a keyswitch which can activate a second address.

HMS-S/-D Intelligent The HMS-S/-D is an intelligent manual station designed to interface with a DLC loop.

The HMS-S is a single-action station; the HMS-D is a double-action station. The HMS

can be flush mounted or surface mounted using the SB-5R mounting box.

HMS-M Intelligent Manual The HMS-M is an intelligent metal manual station designed to interface with a DLC

loop. The HMS-M is a single action station; when used with the Model HMS-FD

Adapter, the HMS-M is double action.

HTRI-M Intelligent Interface The HTRI-M intelligent interface module interfaces direct shorting contact devices

with the DLC loops.The HTRI-M can monitor a normally open or closed dry contact

and it can report the status of the contact.

HTRI-S, HTRI-R and HTRI-D The HTRI-S/-R/-D series modules are intelligent interface modules that interface

direct shorting contact devices with the DLC loops.The HTRI-S is a single-input

module; the HTRI-R is a single-input module with an independently controllable

Form C relay; the HTRI-D is a dual-input module.

HZM Remote Conventional The HZM is a FireFinder-XLS intelligent device that connects a single zone of

conventional devices to a DLC device loop card. The HZM can power up to fifteen

compatible 2-wire, ionization or photoelectric smoke detectors or it can power one

PB-1191 Beam Detector. It can also monitor an unlimited number of shorting devices

such as waterflow switches, thermal detectors, manual stations, etc.

The HZM supports Class A and Class B wiring. The module uses one address on the

device loop. It does not require any mechanical address programming. Use the DPU

Device Programming Unit to program and test the module.

DPU Device Programming The DPU is used to program and test detectors and

devices for MXL and FireFinder-XLS systems. In a

FireFinder-XLS installation, the DPU may be used to

check wiring loops for ground faults and short circuits as

well as to check communication of the installed devices

by displaying the device types and addresses of all

devices on the loop.

Intelligent Manual Station

Manual Station

Station with Metal Housing

Module

Intelligent Interface Modules

Zone Module

Unit

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens FIREFINDER-XLS Instrukcja Szybki Start Strona 17

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens FIREFINDER-XLS