Siemens FIREFINDER-XLS Instrukcja Szybki Start Pobierz pdf (Strona 31)

VOICE SYSTEM 4-1

INTRODUCTION The eight-channel digital evacuation FireFinder-XLS Voice system can be added to the

basic FireFinder-XLS fire alarm system. This is accomplished with the addition of the

DAC-NET Digital Audio card and its accompanying submodules (ZAC, LVM/LPB, SCM-8,

ZIC, FMT, TZC-8B) and zone-installed equipment (speakers, strobes, telephones).

The system is capable of automatically or manually signaling to its installed speaker

zone circuits (ZAC). The signal can be up to eight channels of prerecorded messages

and/or tones including up to two simultaneous channels of live paging. The tones and

prerecorded messages are configurable in the Zeus programming tool and are

available for upload to each installed DAC-NET. A maximum of 32 DAC-NET modules

can be installed in each FireFinder-XLS system. Each DAC-NET may input either its

own tone/message to a channel, or it may be programmed to use a tone/message

from another DAC-NET in the system.

Individual zone circuits (speaker, strobe, telephone) are bundled into geographic

groups during system configuration. These groups are either automatically controlled

by pre-programmed system logic, or manually controlled by the switches located on

one or more Command Stations. Paging, manual control, or monitoring of the speaker

or telephone groups can be performed from any location where an LVM/LPB micro-

phone, SCM switch control module, or PMI is installed.

EQUIPMENT The Control and Indicating equipment of a FinderFinder-XLS Voice system consists of

the following components:

• LED Control Module (LCM)

• Switch Control Module (SCM)

• Live Voice Microphone (LVM)

• Firefighters Master Telephone (FMT)

• Telephone Zone Card (TZC-8B)

• Person Machine Interface (PMI)

COMMAND STATIONS Each FireFinder-XLS Command Station configuration is unique. The requirements of

the project determine the modules needed to achieve the desired functionality. The

Control view of the Zeus Programming tool is used to configure the Command

stations. Each switch on the LVM, SCM and FCM may be configured for any of the

manual operations (See page 4-4).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Brak uwag

Siemens FIREFINDER-XLS Instrukcja Szybki Start Strona 31