Siemens FIREFINDER-XLS Instrukcja Szybki Start Pobierz pdf (Strona 59)

APPENDIX 7

These circuits are intended for 24 hour alarm monitoring only.

UL 1076 requires an HTSW-1 tamper switch as well as a PAL-1 printer. Only Models

HTRI-S/-D/-R may be used as security points. A COMMUNICATION FAILURE with an

HTRI device configured for SECURITY results in a SECURITY EVENT as well as a

communication trouble. When installing an HTRI device in the Zeus tool, be sure to

set the device usage to security; otherwise, the device usage defaults to fire alarm.

• When setting the device address using the DPU, select the normally closed

alarm causing input.

• Connect only one switch per HTRI input.

For proprietary burglary

application (UL 1076):

• Use an HTSW-1 tamper switch to monitor the main enclosure.

• Monitor each HTRI-S/-D/-R related to this application for 24 hours by using a

listed motion detector (to prevent tampering).

• Monitoring of security points is performed at the PMI. The PMI is suitable

for installation at either the protected premises or remotely as a receiving

unit.

SECURITY POINT INSTALLATION

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 71 72

Brak uwag

Siemens FIREFINDER-XLS Instrukcja Szybki Start Strona 59