Siemens SIPART PS2 6DR50xx Instrukcje Operacyjne Pobierz pdf (Strona 116)

Commissioning

9.2 Commissioning linear actuators

SIPART PS2 with and without HART communications

116 Operating Instructions, 09/2007, A5E00074631-07

1. Switch to the "Configuration" mode. To do this, press the operating mode buttons for

at least 5 seconds. The following is shown on the digital display:

2. Call the second parameter "YAGL". Press the

operating mode button for a short while

for this purpose. The following is shown on the digital display depending on the setting:

3. Check whether the value displayed in the "YAGL" parameter matches the setting of the

transmission ratio selector. If required, change the setting of the transmission ratio

selector to 33° or 90°.

4. Set parameter 3 to determine the total stroke in mm. The setting of parameter 3 is

optional. The digital display shows the determined total stroke only at the end of the

initialization phase.

– Press the

operating mode button for a short while if you do not want any

information about the total stroke in mm. You are then directed to parameter 4.

– Call parameter 3 by pressing the

operating mode button for a short while. The

following is shown on the digital display:

5. Call the fourth parameter "INITA". Press the

operating mode button for a short while

for this purpose. The following is shown on the digital display:

6. Start the initialization process. The positioner runs through five initialization steps during

the automatic initialization process. Displays for the initialization steps from "RUN 1" to

"RUN 5" are shown in the lower line on the digital display. The initialization process

depends on the actuator used, and takes up to 15 minutes. To start the initialization,

press the increment button

for at least 5 seconds until the digital display shows the

following:

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 241 242

Brak uwag

Siemens SIPART PS2 6DR50xx Instrukcje Operacyjne Strona 116