Siemens SINUMERIK 802D sl Instrukcja Operatora Pobierz pdf (Strona 121)

NCK alarms

06/2009 Overview of alarms

2-121

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

15360 [Channel %1: ] Illegal target of block search (syntax error)

Parameters: %1 = Channel number

Definitions: The specified search target (block number, label or string) is not allowed in block search.

Reaction: Alarm display.

Remedy: Correct target of block search.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15370 [Channel %1: ] Target of block search not found

Parameters: %1 = Channel number

Definitions: In a block search, an impermissible search target has been specified (e.g. negative block number).

Reaction: Alarm display.

Remedy: Check the specified block number, label or character string. Repeat entry with correct search target.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15380 [Channel %1: ] Block %2 illegal incremental programming in axis %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis

Definitions: The first axis programming after "search to block end point" is performed incrementally. This is not

allowed in the following situations:

- After searching the target a transformation change has taken place.

- A frame with rotation component is active. The programmed axis is involved in the rotation.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Find search destination in which the axes are programmed using an absolute reference.

Deactivate adding of the accumulated search position with SD42444

$SC_TARGET_BLOCK_INCR_PROG = FALSE.

Use search run with calculation "at contour".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15400 [Channel %1: ] Block %2 selected initial INIT block does not exist

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The operator has selected an INI block for a read, write or execution function which:

1. Does not exist in the NCK range or

2. Does not have the necessary protection level required for performing the function.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department.

Check whether the selected INI block is contained in the file system of the NCK. The present protec-

tion level must be selected to be at least equal to (or greater than) the protection level that has been

defined for the read, write or execution function at the time of creating the file.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15410 [Channel %1: ] Block %2 initialization file contains invalid M function

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The only M function allowed in an Init block is the M02, M17 or M30 end-of-program function.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Remove all M functions from the Init block except for the end identifier.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 339 340

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Instrukcja Operatora Strona 121

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl