Siemens SINUMERIK 802D sl Instrukcja Operatora Pobierz pdf (Strona 226)

Overview of alarms 06/2009

Cycle alarms

2-226

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another direction of machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61267 [Channel %1: ] Block %2: Plane infeed too large, residual corners remain

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the plane infeed must not exceed 85%.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a smaller plane infeed, as otherwise residual corners will be left over.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61268 [Channel %1: ] Block %2: Illegal machining direction, residual corners

are left over.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the machining direction does not match the selected delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The machining direction must be selected to match the delimitations.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61269 [Channel %1: ] Block %2: External tool diameter too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Incorrect tool definition.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check angle and diameter of the tool used.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61270 [Channel %1: ] Block %2: Chamfer width too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer width selected too small.

Alarm triggered by the following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase the chamfer width.

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 339 340

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Instrukcja Operatora Strona 226

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl