Siemens SINUMERIK 802D sl Instrukcja Operatora Pobierz pdf (Strona 51)

NCK alarms

06/2009 Overview of alarms

2-51

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10747 [Channel %1: ] Block %2 retraction direction not defined for WAB

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In a WAB retraction block with quarter circle or semi-circle (G248 or G348), the end point in the

machining plane was not programmed, and either G143 or G140 without tool radius compensation is

active.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program. The following changes are possible:

- Indicate end point in the machining plane in the WAB block.

- Activate tool radius compensation (effective for G140 only, not for G143).

- State retraction side explicitly with G141 or G142.

- Perform retraction with a straight line instead of a circle.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10748 [Channel %1: ] Block %2 illegal retract plane with WAB

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: By means of DISRP a position of the retraction plane has been programmed which is not situated

between the safety distance (DISCL) and the starting point (during approach) and/or end point (during

retraction) of the WAB movement.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10750 [Channel %1: ] Block %2 tool radius compensation activated without tool

number

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A tool T... must be selected so that the control can make allowance for the associated compensation

values.

A correction data block (D1) containing the correction values (parameter P1 - P25) is automatically

assigned to each tool (T number). Up to 9 correction data blocks can be assigned to a tool by speci-

fying the required data block with the D number (D1 - D9).

The cutter radius compensation (CRC) is allowed for if function G41 or G42 is programmed. The cor-

rection values are contained in parameter P6 (geometry value) and P15 (wear value) of the active cor-

rection data block Dx.

Reaction: Correction block is reorganized.

Interpreter stop

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Before calling the CRC with G41/G42, program a tool number under the address T...

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10751 [Channel %1: ] Block %2 danger of collision due to tool radius

compensation

Parameters: %1 = Channel number

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 339 340

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Instrukcja Operatora Strona 51

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl