Siemens SINUMERIK 802D sl Instrukcja Operatora Pobierz pdf (Strona 319)

06/2009 System reactions on alarms

4-319

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Name STOPATENDBYALARM

Effect Stop at end of block.

− NC Stop on alarm at end of block

Name SHOWALARMAUTO

Effect The alarm is displayed whenever bit 0 of machine data ENABLE_ALARM_MASK is set.

The reaction should be set whenever an alarm should only occur during automatic

mode without manual operation by the user.

− Alarm reaction in automatic mode

Name SHOWWARNING

Effect The alarm is displayed whenever bit 1 of machine data ENABLE_ALARM_MASK is set.

It is designed for warnings which should normally be suppressed.

− Alarm view

Name ALLBAGS_NOREADY

Effect The Ready is canceled in all mode groups. The reaction thus corresponds to an NCK-

REACTIONVIEW|NOREADY, the difference being that the NC READY relay is not can-

celed and the corresponding VDI bit is not set. This is desirable in the event of an

emergency stop for example.

− Mode group not ready

Name DELAY_ALARM_REACTION

Effect If this alarm reaction is configured in the alarm handler, all alarm reactions for alarms,

which occur at this point, are buffered channel-specifically and are, therefore, not active.

The alarms are displayed on the HMI. Mode group and NC-wide reactions are trans-

ferred. The reaction is cleared by activating the clearDelayReaction call or by an alarm,

which has configured NO_DELAY_ALARM_REACTION. This activates all the delayed

alarm reactions.

− All channel-specific alarm reactions delayed on alarm, alarm display

Name NO_DELAY_ALARM_REACTION

Effect The DELAY_ALARM_REACTION state is canceled.

− The alarm reaction delay is canceled.

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 339 340

Brak uwag

Siemens SINUMERIK 802D sl Instrukcja Operatora Strona 319