Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 119)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-119

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14028 Channel %1 block %2 motion-synchronous action: Technology cycle

programmed with too many parameters

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Maximum number of transfer parameters for one technology cycle exceeded.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change technology cycle

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14030 Channel %1 block %2 combine OSCILL and POSP during oscillation with

infeedmotion

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When oscillating controlled by synchronized actions, the assignment of oscillating and infeed axis

(OSCILL) as well as the definition of the infeed (POSP) must be carried out in one NC block.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14033 Channel %1 block %2 involute: no end point programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No end point was programmed for the involute. This is either possible via direct programming with the

geometry axis identifiers or by specifying the angle between start and end vector.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14034 Channel %1 block %2 involute: angle of rotation too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: With programming of the angle of rotation (with AR) for involute interpolation, the maximum program-

mable angle of rotation is limited if the involute is moving towards the basic circle. The maximum value

is reached if the involute touches the basic circle. With

MD_INVOLUTE_AUTO_ANGLE_RESTRICTION = TRUE, each angle is accepted without an alarm;

if necessary, the angle is automatically limited during interpolation.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14035 Channel %1 block %2 involute: start point invalid

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 119

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 119

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl