Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 300)

Overview of alarms 06/2007

Cycle alarms

2-300

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61265 Channel %1 block %2: Too many restrictions, use rectangular pocket

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling a maximum of only 3 sides can be delimited.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use pocket cycle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61266 Channel %1 Block %2: Illegal machining direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the delimitations and the direction of machining do not match.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another direction of machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61267 Channel %1 Block %2: Plane infeed too large, residual corners remain

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the plane infeed must not exceed 85%.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a smaller plane infeed, as otherwise residual corners will be left over.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61268 Channel %1 block %2: Illegal machining direction, residual corners are

left over.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the machining direction does not match the selected delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The machining direction must be selected to match the delimitations.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 391 392

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Dokumentacja Strona 300

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl