Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 84)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-84

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10930 Channel %1 block %2 interpolation type not allowed in stock removal

contour

Parameters: %1 = channel number

%2 = block number, label

Definitions: The contour of the stock removal cycle (CYCLE 95) contains different path commands than: G00,

G01, G02, G03, CIP or CT. The contour program may only contain contour elements that derive from

these path conditions (i.e. no thread blocks, no spline blocks, etc.).

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Only program path elements that consist of straight lines or circles as a stock removal contour.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10931 Channel %1 block %2 incorrect stock removal contour

Parameters: %1 = channel number

%2 = block number, label

Definitions: The contour of the stock removal cycle (CYCLE 95) contains different path commands than:

Full circle

Overlapping contour elements

Wrong start position

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The above errors must be corrected in the program for the stock removal contour.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10932 Channel %1 block %2 preparation of contour has been restarted

Parameters: %1 = channel number

%2 = block number, label

Definitions: The stock removal cycle CYCLE 95 was interrupted during a preparatory phase of the stock removal

contour.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: No interruptions are permitted during contour preparation in the stock removal cycle CYCLE 95.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10933 Channel %1 block %2 contour programm does not contain enough

contour blocks

Parameters: %1 = channel number

%2 = block number, label

Definitions: The program in which the stock removal contour is programmed contains fewer than 3 blocks with

motions in both axes in the machining plane. The cutting cycle (CYCLE 95) has been aborted.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase the size of the program with the stock removal contour to include at least 3 NC blocks with

movements in both axes of the current machining plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 84

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 84

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl