Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 305)

Cycle alarms

06/2007 Overview of alarms

2-305

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61286 Channel %1 block %2: machining not possible, check tool angle.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Machining not possible with the specified tool.

Alarm triggered by following cycles: F_UCUT_T.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61287 Channel %1 block %2: no master spindle active.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No master spindle active.

Alarm triggered by following cycle: F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Activate the master spindle (machine data 20090).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61300 Channel %1 Block %2: Probe defective

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61304 Channel %1 Block %2: Allowance

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61305 Channel %1 Block %2: Dimension too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 391 392

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Dokumentacja Strona 305

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl