Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 135)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-135

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14401 Channel %1 block %2 transformation not available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The required transformation is not available.

Example:

The following has been programmed: N220 TRACYLI(3) ;Transformation

no. 3-ON

However, only transformation 1 and 2 applies.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

Modify part program; program defined transformations only.

Check MD 24100 TRAFO_TYPE_n (assigns the transformation to part program instructions).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14403 Channel %1 block %2 preprocessing and main run might not be

synchronized

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Positioning axis curves cannot be predicted reliably. Consequently, the position in the MCS is not

known exactly. It might therefore be possible that a change in the multiple significance of the transfor-

mation has been performed in the main run although no provision was made for this in the preprocess-

ing run.

Reaction: Alarm display.

Remedy: Change part program. Synchronize preprocessing run and main run.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

14404 Channel %1 block %2 illegal parameterization of transformation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Error has occurred when selecting transformation.

Possible error causes can be:

An axis traversed by the transformation has not been enabled:

Is in spindle mode (-> enable with SPOS)

Is in POSA mode (-> enable with WAITP)

Is concurrent Pos axis (-> enable with WAITP)

Parameterization via machine data has an error.

Axis or geometry axis assignment to the transformation has an error.

Machine data has an error (-> modify machine data, cold restart)

Transformation-dependent error causes can be:

TRANSMIT:

The current machine axis position is unsuitable for selection (e.g. selection in the pole) (-> change

position slightly).

Parameterization via machine data has an error.

Special requirement with respect to the machine axis has not been satisfied (e.g. rotary axis is not a

modulo axis) (-> modify machine data, cold restart).

TRACYL:

The programmed parameter is not allowed when transformation is selected.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

Change the part program or change the machine data.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 135

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 135

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl