Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 58)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-58

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10602 Channel %1 block %2 velocity limitation during thread cutting

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the displayed thread block, the axis would exceed its maximum velocity when the spindle override

is in the maximum position.

Reaction: Local alarm reaction.

Alarm display.

Remedy: If the axis velocity is not limited (faultless thread) no remedial measures are necessary. Otherwise, a

lower spindle speed must be programmed for the thread block.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

10604 Channel %1 block %2 thread lead increase too high

Parameters: %1 = channel number

%2 = block number, label

Definitions: The thread lead increase cause axis overload.

A spindle override of 100% is assumed during verification.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Reduce the spindle speed, thread lead increase or path length in the part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10605 Channel %1 block %2 thread lead decrease too high

Parameters: %1 = channel number

%2 = block number, label

Definitions: The thread lead decrease is causing an axis standstill in the thread block.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Reduce the thread lead decrease or path length in the part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10607 Channel %1 block %2 thread with frame not executable

Parameters: %1 = channel number

%2 = block number, label

Definitions: The current frame is corrupting the reference between the thread length and the thread lead.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Perform thread cutting with G33, G34, G35 without frame

Use G63 or G331/G332.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10610 Channel %1 axis %2 not stopped

Parameters: %1 = channel number

%2 = block number, label

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 58

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 58

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl