Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 141)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-141

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14700 Channel %1 block %2 timeout during command to interpreter

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A timeout has occurred for control-internal commands such as part program selection, reset or change

configuration-specific machine data.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

If the runtime error occurred as the result of a temporary excessive load on the system (e.g. in the

MMC area) error-free execution is possible by repeating the program or operator action.

Otherwise, the A&D MC system support should be contacted with a precise description of the error

situation:

SIEMENS AG, After-Sales Support for A&D MC Products, Hotline

(Phone: see page 1-9)

Program Con-

tinuation:

Switch control OFF - ON.

14701 Channel %1 block %2 number of available NC blocks reduced by %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Number of blocks not available

Definitions: After reset, it has been found that the number of available blocks has decreased compared with the

last reset. This is due to a system error. Part program execution can be resumed after the alarm has

been acknowledged.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Proceed as in the case of a system error.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14710 Channel %1 block %2 error in initialization sequence in function %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Index for section

Definitions: The start-up and reset of the control produces initialization blocks. This can cause errors because of

incorrect machine data settings.

The parameter %3 specifies the section of the initblock generation in which the error occurred:

Section 0: Error during synchronization preprocessing/main run

Section 1: Error on selection of tool length compensation.

Section 2: Error on selection of transformation.

Section 3: Error on selection of zero offset.

The cycle interfaces are also read in during the power-up procedure. If an error occurs here, it will be

reported with "section 5".

Reaction: Interpreter stop

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: For section 0-3: Load the standard machine data

For section 5: Reload the cycles

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 141

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 141

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl