Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 57)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-57

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10261 Channel %1 communication overload for block preparation

Parameters: %1 = Channel number

Definitions: The internal communication between the NCK modules that evaluate the channel-specific VDI signals

(START/STOP/RESET/DDTG/ASUBS/...) and the block preparation are overloaded. The block prep-

aration modules are not being allocated enough computing time.

Reaction: NC not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: More processor time must be allocated to the block preparation modules. Machine data

$MN_IPO_SYSCLOCK_TIME_RATIO or $MN_SYSCLOCK_CYCLE_TIME can be increased for this

purpose.

Program Con-

tinuation:

Switch control OFF - ON.

10299 Channel %1 Auto-Repos function is not enabled

Parameters: %1 = channel number

Definitions: The Auto-Repos function (operating mode) was selected in the channel but is not implemented.

Reaction: Alarm display.

Remedy: This message is purely informational.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

10600 Channel %1 block %2 auxiliary function during thread cutting active

Parameters: %1 = channel number

%2 = block number, label

Definitions: An auxiliary function output is programmed in a thread cutting block.

Reaction: Alarm display.

Remedy: Consequential errors can occur if the machining path of the thread block is too short and further blocks

(thread blocks) follow in which no machining stop may occur.

Possible remedies:

• Program a longer path and/or a lower traversing rate.

• Output auxiliary function in another block (program section).

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

10601 Channel %1 block %2 zero velocity at block end point during thread

cutting

Parameters: %1 = channel number

%2 = block number, label

Definitions: This alarm occurs only when several blocks with G33 follow in succession. The block end velocity in

the specified block is zero although a further velocity block follows. Possible causes could be:

G09

Auxiliary function after motion

Auxiliary function output before the motion of the following block

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify the NC part program by removing any programmed "Stop at end of block" G09.

Modify general MD 11110 AUXFU_GROUP_SPEC [n] for selecting the output time of an auxiliary

function group by changing "Auxiliary function output before/after the movement" to "Auxiliary function

output during the movement".

Bit 5 = 1:Auxiliary function output before the motion

Bit 6 = 1:Auxiliary function output during the motion

Bit 7 = 1:Auxiliary function output after the motion

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 391 392

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Dokumentacja Strona 57

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl