Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 20)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-20

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: An axis identifier is expected for the displayed MD in accordance

with the axis configuration in the AXCONF_MACHAX_USED

and MD 20050 AXCONF_GEOAX_ASSIGN_TAB.

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department.

Check axis configuration and enter the missing identifier into the MD or, should the axis not exist,

specify for this channel axis the machine axis 0 in MD 20070 AXCONF_MACHAX_USED. If this con-

cerns a geometry axis that is not to be used (this applies only for 2-axis machining, e.g. on lathes),

then channel axis 0 must be entered additionally in MD 20050 AXCONF_GEOAX_ASSIGN_TAB for

the relevant geometry axis.

Program Con-

tinuation:

Switch control OFF - ON.

4032 Channel %1 wrong identifier for facing axis in %2

Parameters: %1 = channel number

%2 = string: MD identifier

Definitions: According to the axis configuration in MD 20150 GCODE_RESET_VALUES or MD 20100

DIAMETER_AX_DEF, a facing axis identifier is expected at the specified location.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department.

Add the correct identifier.

Program Con-

tinuation:

Switch control OFF - ON.

4040 Channel %1 axis identifier %2 not consistent with machine data %3

Parameters: %1 = channel number

%2 = string: axis identifier

%3 = string: MD identifier

Definitions: The use of the specified axis identifier in the displayed MD is not consistent the channel's axis config-

uration stated in the MD 20070 AXCONF_MACHAX_USED and MD 20050

AXCONF_GEOAX_ASSIGN_TAB.

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department.

Check and correct the identifier used in the MD 10000 AXCONF_

MACHAX_NAME_TAB, MD 20080 AXCONF_CHANAX_NAME_TAB and/or MD 20050

AXCONF_GEOAX_NAME_TAB.

Program Con-

tinuation:

Switch control OFF - ON.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 20

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 20

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl