Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 162)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-162

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16010 Channel %1 block %2 machining stop after lift fast

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: LIFTFAST without interrupt routine (Asup) has been programmed. The channel is stopped after the

lift motion has been carried out.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: After the channel stop, the axes must be retracted manually in JOG and the program aborted with

Reset.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16015 Channel %1 block %2 wrong axis identifier %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name

Definitions: Axis names from different coordinate systems were used to program axes for LIFTFAST. The retrac-

tion movement is no longer clear.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Use axis names from one coordinate system.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16016 Channel %1 block %2 no retraction position programmed for axis %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name

Definitions: The retraction enable was programmed for LIFTFAST without defining a retraction position for the

axis. The retraction movement is no longer clear.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program a retraction position for the relevant axis.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16020 Channel %1 repositioning in block %2 is not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Programming or operator action incorrect: A block is to be repositioned for which repositioning infor-

mation exists.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: If necessary, change the part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 162

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 162

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl