Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 290)

Overview of alarms 06/2007

Cycle alarms

2-290

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Definitions: The tool radius is too large for machining.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61220 Channel %1 Block %2: Tool radius too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool radius is too small for machining.

Alarm triggered by following cycles: CYCLE78.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61221 Channel %1 Block %2: No tool active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No tool active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61222 Channel %1 Block %2: Plane infeed greater than tool diameter

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The plane infeed must not be greater than the tool diameter.

Alarm triggered by following cycles: CYCLE79, , E_MI_PL, E_PO_CIR, E_PO_REC, F_PO_CIR,

F_PO_REC.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reduce plane infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61223 Channel %1 Block %2: Approach path too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach path must not be less than zero.

Alarm triggered by following cycles: E_MI_CON, F_MI_CON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a greater value for the approach path.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 391 392

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Dokumentacja Strona 290

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl