Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 291)

Cycle alarms

06/2007 Overview of alarms

2-291

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61224 Channel %1 Block %2: Retract path too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The retract path must not be less than zero.

Alarm triggered by following cycles: E_MI_CON, F_MI_CON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a greater value for the retract path.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61225 Channel %1 block %2: Swivel data record unknown

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt was made to access a swivel data block which has not been defined.

Alarm triggered by following cycles: E_TCARR, F_TCARR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another swivel data block or define a new swivel data block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61226 Channel %1 block %2: Inclinable head cannot be exchanged

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameter "Swivel data block" is set to "No". In spite of this, an attempt has been made to change

the swivel head.

Alarm triggered by following functions: E_TCARR, F_TCARR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Set the parameter "Swivel data block" in the start-up screen "Rotary axes" to "Automatic" or "Manual".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61231 Channel %1 block %2: ShopMill program %4 not executable, as not

tested by ShopMill

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Program name

Definitions: Before a ShopMill program can be executed, it has to be tested by ShopMill.

Alarm triggered by following cycle: E_HEAD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The program has to be simulated first in ShopMill or loaded into the operating mode "Machine auto"

by ShopMill.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61232 Channel %1 block %2: Impossible to load magazine tool

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 291

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 291

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl