Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 131)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-131

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14198 Channel %1 block %2 illegal change of tool direction with tool offset

Parameters: %1 = Channel number

%2 = Block number, label.

Definitions: If an offset is active in the tool direction, block change is not possible if this would change the assign-

ment of the offset axes to the channel axes (plane change, tool change, cutter <=> turning tool, geom-

etry axis replacement).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change the part program

Reduce the offset in tool direction to zero.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14199 Channel %1 block %2 illegal plane change for tool with diameter

component

Parameters: %1 = Channel number

%2 = Block number, label.

Definitions: If a tool has a wear or length component which is evaluated as a diameter for the facing axis (bit 0

and/or bit 1 in MD 20360 TOOL_PARAMETER_DEF_MASK is set) and bit 2 of this MD is also set,

this tool may only be used in the plane active on tool selection. A plane change results in an alarm.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change the part program

Reset bit 2 in the MD 20360 TOOL_PARAMETER_DEF_MASK.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14200 Channel %1 block %2 negative polar radius

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the endpoint specification of a traversing block with G00, G01, G02 or G03 in polar coordinates, the

polar radius entered for the vocabulary word RP=... is negative.

Definition of terms:

Specification of end of block point with polar angle and polar radius, referring to the current pole (pre-

paratory functions: G00/G01/G02/G03).

New definition of the pole with polar angle and pole radius, referring to the reference point selected

with the G function.

G110 ... Last programmed point of the plane

G111 ... Zero point of the current WCS

G112 ... last pole

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the NC part program – valid inputs for the polar radius are only positive absolute values that

specify the distance between the current pole and the block end point (the direction is defined with the

polar angle AP=... ).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 131

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 131

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl