Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 69)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-69

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10748 Channel %1 block %2 illegal retract plane with WAB

Parameters: %1 = channel number

%2 = block number, label

Definitions: By means of DISRP a position of the retraction plane has been programmed which is not situated

between the safety distance (DISCL) and the starting point (during approach) and/or end point (during

retraction) of the SAR movement.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10750 Channel %1 block %2 tool radius compensation activated without tool

number

Parameters: %1 = channel number

%2 = block number, label

Definitions: A tool T... must be selected so that the control can make allowance for the associated compensation

values.

A correction data block (D1) containing the correction values (parameter P1 - P25) is automatically

assigned to each tool (T number). Up to 9 correction data blocks can be assigned to a tool by speci-

fying the required data block with the D number (D1 - D9).

The tool radius compensation (TRC) is allowed for if function G41 or G42 is programmed. The correc-

tion values are contained in parameter P6 (geometry value) and P15 (wear value) of the active cor-

rection data block Dx.

Reaction: Correction block is reorganized.

Interpreter stop

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Before calling the TRC with G41/G42, program a tool number under the address T...

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10751 Channel %1 block %2 danger of collision due to tool radius

compensation

Parameters: %1 = channel number

%2 = block number, label

Definitions: The "Bottleneck detection" (calculation of intersection for the following compensated traversing

blocks) has not been able to calculate a point of intersection for the reviewed number of traversing

blocks. So it may be that one of the equidistant paths violates the workpiece contour.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Check the part program and modify the programming if possible such that inside corners with smaller

paths than the correction value are avoided. (Outside corners are not critical, since the equidistants

are extended or added to always obtain an intersection point).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 69

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 69

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl