Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 294)

Overview of alarms 06/2007

Cycle alarms

2-294

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61240 Channel %1 Block %2: Wrong feed type

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The feed type is not possible for this machining.

Alarm triggered by following cycles: F_DRM_DR, F_DRM_PE, F_DRM_RE, F_DRM_SI, F_GROOV,

F_MIM_TR, F_ROUGH, F_SP_EF, F_UCUT_T

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check feed type.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61241 Channel %1 Block %2: Retraction plane not defined for this machining

direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No retraction plane has been defined for the selected machining direction.

Alarm triggered by following cycles: F_SP_RP, F_SP_RPT.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Define the missing retraction plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61242 Channel %1 block %2: Wrong machine direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The machining direction has been specified incorrectly.

Alarm triggered by following cycles: F_DR, F_DR_PEC, F_DR_REA, F_DR_SIN, F_DR_TAP,

F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE, F_DRM_RE, F_DRM_SI, F_DRM_TA,

F_MI_CON, F_MI_EDG, F_MI_TR, F_MI_TXT, F_MIM_TR, F_PI_CIR, F_PI_REC, F_PO_CIR,

F_PO_REC, F_SL_CIR, F_SL_LON, F_TAP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the programmed machining direction.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61243 Channel %1 block %2: Correct tool change point, tool tip in

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool change point must be situated so far outside the retraction area that no tool protrudes into

the retraction area on turret swivelling.

Alarm triggered by following cycle: F_SP_RP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify another tool change point.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 391 392

Siemens SINUMERIK 802D sl Dokumentacja Strona 294

Komentarze do niniejszej Instrukcji

Siemens SINUMERIK 802D sl Dokumentacja Strona 294

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl