Siemens SINUMERIK 802D sl Dokumentacja Pobierz pdf (Strona 129)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-129

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: If tool compensation (G43/G44) is activated in the ISO M language mode, the linear type of interpola-

tion must be active.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14180 Channel %1 block %2 H number %3 is not defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified H number is not assigned to any tool (ISO M).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14185 Channel %1 block %2 D number %3 is not defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified D number is not assigned to any tool (ISO M).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14190 Channel %1 block %2 H number with G49

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: G49 (select tool length compensation) and an H word not equal to H0 have been programmed simul-

taneously.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 391 392

Komentarze do niniejszej Instrukcji

Brak uwag

Siemens SINUMERIK 802D sl Dokumentacja Strona 129

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Siemens SINUMERIK 802D sl